NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 325)

7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
9. To refresh the page, click the Refresh button.
The following table describes the view-only fields on the page.
Table 79. MLD snooping configuration information
Definition Field
The number of multicast control frames that were processed. Multicast Control Frame Count
The interface on which MLD snooping is administratively enabled. MLD
snooping must be enabled globally and on an interface for the interface
to be able to snoop MLD packets to determine which segments should
receive multicast packets directed to the group address. Interfaces Enabled for MLD
Snooping
The VLAN on which MLD snooping is administratively enabled. VLAN IDs Enabled For MLD
Snooping
Configure MLD snooping manually
You can manually configure the settings for MLD snooping, which is used to build
forwarding lists for IPv6 multicast traffic.
You can also configure MLD snooping automatically (see Configure MLD snooping
automatically with MLD Plus mode on page 324).
To configure the settings for MLD snooping manually:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Multicast > MLD Snooping > Configuration.
The Configuration page displays.
Main User Manual 325 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual