NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 168)

Table 42. PoE classes and PoE power allocations
Power Delivered to
the PD Maximum Power
Reserved for the PD Class Description Compatible PoE
Standard Device
Class
0.44W–15.8W 15.4W Default power (full) PoE, PoE+, and PoE++ 0
0.44W–3.84W 4.0W Very low power PoE, PoE+, and PoE++ 1
3.84W–7.2W 7.0W Low power PoE, PoE+, and PoE++ 2
6.49W–15.9W 15.4W Mid power PoE, PoE+, and PoE++ 3
12.95W–30.8W 30.0W High power PoE+ and PoE++ 4
25.5W–47.0W 45.0W Ultra high power PoE++ 5
51.0W–64.4W 90.0W Ultra high power PoE++ 6
62.0W–81.1W 75.0W Ultra high power PoE++ 7
71.0W–96.5W 90.0W Ultra high power PoE++ 8
Set the PoE system usage threshold and
power management mode
You can configure a threshold for the PoE usage level at which a trap is sent and you
can set the power management mode that the switch uses to deliver power to the
requesting powered devices (PDs).
To set the PoE system usage threshold and power management mode:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > PoE > Basic > PoE Configuration.
The PoE Configuration page displays.
Main User Manual 168 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual