NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 80)

6. Select the Admin Mode Enable or Disable radio button.
The default is Enable.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Manage the PTP interface settings
On a standalone switch, by default, PTP is enabled globally on all interfaces. In a switch
stack, by default, PTP is disabled for all interfaces. You can select individual interfaces
on which you can enable or disable PTP. If you disable PTP on an interface, the interface
does not support PTP pass-through.
To configure the PTP end-to-end transparent clock settings for one or more
interfaces:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Management > PTP TC > Interface Configuration.
The Interface Configuration page displays.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
• 1: Only physical interfaces are displayed. This is the default setting.
• LAG: Only LAGs are displayed.
• All: Both physical interfaces and LAGs are displayed.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
Main User Manual 80 Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual