NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 441)

• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the Admin Mode menu, select Enable or Disable to enable or disable MLD
for the interface.
The default is Disable.
9. In the Version field, specify the version of MLD for the interface.
The version can be 1 or 2. The default is 2.
10. In the Query Interval field, enter the frequency in seconds at which MLD host-query
packets are to be transmitted on the interface.
The value is from 1 to 3600. The default is 125.
11. In the Query Max Response Time field, enter the maximum query response time,
in milliseconds, to be advertised in MLDv2 queries on the interface.
The value is from 0 to 65535. The default is 10000 milliseconds.
12. In the Startup Query Interval field, enter the number of seconds between the
transmission of startup queries on the interface.
The value is from 1 to 300. The default is 31.
13. In the Startup Query Count field, enter the number of queries to be sent on startup,
separated by the startup query interval.
The value is from 1 to 20. The default is 2.
14. In the Last Member Query Interval field, enter the last member query interval in
milliseconds.
This value is the maximum response time to be inserted into group-specific queries
sent in response to leave group messages, and is also the period between
group-specific query messages. The value is from 0 to 655355. The default is 1000
milliseconds.
15. In the Last Member Query Count field, enter the number of queries to be sent on
receiving a leave group report.
The value is from 1 to 20. The default is 2.
16. Click the Apply button.
Your settings are saved.
17. To save the settings to the running configuration, click the Save icon.
The following table describes the nonconfigurable information that is displayed.
Main User Manual 441 Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual