NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 421
8. To save the settings to the running configuration, click the Save icon.
Configure a static IPv4 PIM rendezvous point for a group
You can add a new or change an existing static IPv4 PIM rendezvous point (RP) for a
group.
To add or change a static IPv4 PIM RP for a group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > PIM > Static RP Configuration.
The Static RP Configuration page displays.
6. If you are changing an existing static RP, select the check box for the static RP.
7. In the RP Address field, specify the IPv4 address for the static RP.
8. In the Group Address field, specify the IPv4 address for the group to which the static
RP applies.
9. In the Group Mask field, specify the mask for the group to which the static RP applies.
10. From the Override menu, select Enable or Disable to enable or disable the override
capacity of a static RP over an RP that is learned from a BSR.
If you select Enable and conflict occurs, a static RP overrides an RP that is learned
from a BSR.
11. Do one of the following:
• If you are adding a new static RP, click the Add button.
Your settings are saved. The static RP is added.
• If you are changing an existing static RP, click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
Main User Manual
421
Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual