NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 348)

To configure one or more IPv4 routing interfaces:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > IP > Advanced > IP Interface Configuration.
The IP Interface Configuration page displays.
6. Select whether to display physical interfaces, VLANs, or both by clicking one of the
following links above the table heading:
• 1: Only physical interfaces are displayed. This is the default setting.
• VLANS: Only VLANs are displayed.
• All: Both physical interfaces and VLANs are displayed.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. In the Description field, enter a description for the interface.
9. From the IP Address Configuration Method menu, select the method by which an
IP address is configured on the interface: None, Manual, or DHCP.
By default, the method is None. Use the None method to reset the DHCP method.
Note: When you change the configuration method from DHCP to None, a minor
delay occurs before the page refreshes.
Main User Manual 348 Manage Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual