NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 724
• Rx: Ingress (received) traffic only is mirrored. This option is not available for
a VLAN.
• Tx: Egress (transmitted) traffic only is mirrored. This option is not available
for a VLAN.
12. Click the Apply button.
Your settings are saved.
If the port is configured as a source port, the Status field displays Mirrored.
13. To save the settings to the running configuration, click the Save icon.
Configure the switch as an RSPAN destination switch
You can configure the switch as an RSPAN destination switch that receives traffic from
another switch that functions as an RSPAN source switch.
You can create up to four RSPAN destination switch configurations.
To configure the switch as an RSPAN destination switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Monitoring > Mirroring > RSPAN Destination Switch Configuration.
The RSPAN Destination Switch Configuration page displays.
6. From the Session ID menu, select 1, 2, 3, or 4 as the RSPAN destination switch
session ID.
You can set up four RSPAN destination switch configurations that functions
independently from each other.
7. Enable or disable the RSPAN destination switch configuration by selecting one of
the following Admin Mode radio buttons:
Main User Manual
724
Monitor the Switch and Network
AV Line of Fully Managed Switches M4250 Series Main User Manual