Configure the auto-voip oui-based properties – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 220
7. In the Protocol Based Global Settings section, specify the Auto VoIP settings for the
interfaces:
a. Select whether to display physical interfaces, LAGs, or both by clicking one of
the following links above the table heading:
• 1: Only physical interfaces are displayed. This is the default setting.
• LAG: Only LAGs are displayed.
• All: Both physical interfaces and LAGs are displayed.
b. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port,
or type the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
c. From the Auto VoIP Mode menu, select to enable or disable the Auto VoIP mode
for the interface.
Auto-VoIP is disabled by default.
8. Click the Apply button.
Your settings are saved.
The Operational Status field show if the interface is up or down.
9. To save the settings to the running configuration, click the Save icon.
Configure the Auto-VoIP OUI-based properties
With organizationally unique Identifier (OUI)–based Auto-VoIP, voice prioritization is
provided based on OUI bits.
To configure the Auto-VoIP OUI-based properties:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
Main User Manual
220
Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual