NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 446)

Table 127. MLD traffic statistics information
Description Field
The number of valid MLD packets received by the switch. Valid MLD Packets Received
The number of valid MLD packets sent by the switch. Valid MLD Packets Sent
The number of valid MLD queries received by the switch. Queries Received
The number of valid MLD queries sent by the switch. Queries Sent
The number of valid MLD reports received by the switch. Reports Received
The number of valid MLD reports sent by the switch. Reports Sent
The number of valid MLD leave messages received by the switch. Leaves Received
The number of valid MLD leave messages sent by the switch. Leaves Sent
Configure an MLD proxy interface
You can configure an MLD proxy interface. The following requirements apply:
• Routing, MLD, and multicast must be globally enabled on the switch.
• You must configure at least one routing interface.
• The MLD proxy interface cannot be the same interface as an MLD routing interface.
To configure an MLD proxy interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > IPv6 Multicast > MLD > Proxy Interface Configuration.
The Proxy Interface Configuration page displays.
Main User Manual 446 Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual