NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 423)

To add or change a static IPv4 multicast route:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > Static Routes Configuration.
The Static Routes Configuration page displays.
6. If you are changing an existing static multicast route, select the check box for the
route.
For an existing static route, you can change the metric only.
7. In the Source IP field, specify the IPv4 address of the multicast packet source.
8. In the Source Mask field, specify the subnet mask of the multicast packet source.
9. In RPF Neighbor field, specify the IPv4 address of the neighbor RPF router that is
located between the switch and the multicast source.
10. In the Metric field, specify the link state cost of the path from the multicast source
to the switch.
The range is from 0 to 255.
11. Do one of the following:
• If you are adding a new static multicast route, click the Add button.
Your settings are saved. The static multicast route is added.
• If you are changing an existing static multicast route, click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
Delete a static multicast route for an IPv4 address
You can delete a static IPV4 multicast route that you no longer need.
Main User Manual 423 Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual