beautypg.com

NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 50

background image

associated with the switch’s management VLAN do not affect the configuration of the
front panel ports through which traffic is switched or routed.

To access the switch over a network you must first configure an IP address and subnet
mask for the switch. You can configure the IP information using any of the following:

DHCP

Terminal interface through the EIA-232 port

After you establish in-band connectivity, you can change the IP information using any
of the following:

Terminal interface through the EIA-232 port

Terminal interface through Telnet

SNMP-based management

Web-based management

To configure an IPv4 management VLAN or reset the IPv4 management VLAN:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select System > Management > Management Interfaces > IPv4 Management

VLAN Configuration.
The IPv4 Management VLAN Configuration page displays.

6. In the Management VLAN ID field, specify the management VLAN ID of the switch.

The IPv4 management VLAN is used for management of the switch. You can configure
any value in the range of 1 to 4093.

7. Select the Enable or Disable Routing Mode radio button to enable or disable global

routing on the switch.
The default value is Enable.

Main User Manual

50

Configure Switch System
Information

AV Line of Fully Managed Switches M4250 Series Main User Manual