NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 49)

• Bootp: During the next boot cycle, the BootP client on the device broadcasts a
BootP request to acquire information from a BootP server on the network.
The IP Address, Subnet Mask, and Default Gateway field display the information
is dynamically acquired.
• DHCP: During the next boot cycle, the DHCP client on the device broadcasts a
DHCP request to acquire information from a DHCP server on the network.
The IP Address, Subnet Mask, and Default Gateway field display the information
is dynamically acquired.
• None: The device does not attempt to acquire network information dynamically.
You must configure the address settings manually:
• IP Address: Specify the IP address of the interface.
• Subnet Mask: Specify the IP subnet mask for the interface.
• Default Gateway: Specify the default gateway for the IP interface.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
The following table describes the nonconfigurable fields on the page.
Table 11. IPv4 service port configuration information
Description Field
The burned-in MAC address used for out-of-band connectivity. Burned-in MAC Address
Indicates whether the link status is up or down. Interface Status
If the selection is DHCP, the DHCP client ID. DHCP Client Identifier
Configure an IPv4 management VLAN
For you to manage the switch over the main UI, you must define the management IP
address. A management VLAN interface is created by default and it gets an IP address
if a DHCP server is present. If the management VLAN interface cannot get an IP address,
the automatically assigned fallback IPv4 address is 169.254.100.100 and the subnet
mask is 255.255.0.0.
A management VLAN is used as the default source interface for the syslog, the message
log, an SNMP client, and so on. The network interface is disabled by default.
The management VLAN is the logical interface used for in-band connectivity with the
switch through any of the switch’s front panel ports. The configuration parameters
Main User Manual 49 Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual