NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 350)

19. From the ICMP Redirects menu, select Enable or Disable to enable or disable the
ICMP redirecting mode.
The interface sends an ICMP redirect message only if this function is enabled both
globally and on the interface. The default is Enable.
20. In the IP MTU field, specify the maximum size of IP packets that are sent on the
interface.
The IP MTU is the maximum frame size minus the length of the Layer 2 header. The
range is from 68 bytes to the MTU size that is supported by the interface link. The
default is 1500. A value of 0 indicates that the IP MTU is not configured, in which
case the interface uses the MTU size that is supported by the interface link.
21. Click the Apply button.
Your settings are saved.
22. To save the settings to the running configuration, click the Save icon.
The following table describes the nonconfigurable fields on the page.
Table 95. IP Interface Configuration
Description Field
The VLAN ID for the interface. VLAN ID
The physical link data rate of the interface. Link Speed Data Rate
The active or inactive state of the interface (Active or Inactive). Active State
The MAC address that is associated with the interface. MAC Address
The link-up or link-down state of the interface. (Link UP or Link Down.) An
interface is considered active if it the link is up and the interface is in the
forwarding state. Link State
The link status of the routing interface (Up or Down). Routing Interface Status
Delete the routing IP address from an IPv4 routing interface
You can delete the routing IP address from one or more IPv4 routing interfaces.
To delete the routing IP address from one or more IPv4 routing interfaces:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
Main User Manual 350 Manage Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual