beautypg.com

NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 451

background image

Configure static multicast routes for IPv6 addresses

You can add a new or change an existing static IPv6 multicast route.

To add or change a static IPv6 multicast route:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Routing > IPv6 Multicast > Static Routes Configuration.

The Static Routes Configuration page displays.

6. If you are changing an existing static multicast route, select the check box for the

route.
For an existing static route, you can change the metric only.

7. In the Source IP field, specify the IPv6 address of the multicast packet source.

8. In the Prefix Length field, specify the IPv6 prefix length of the multicast packet

source.

9. In RPF Neighbor field, specify the IPv6 address of the neighbor RPF router that is

located between the switch and the multicast source.

10. In the Metric field, specify the link state cost of the path from the multicast source

to the switch.
The range is from 0 to 255.

11. From the RPF Interface menu, select the interface that is connected to the RPF

neighbor.

12. Do one of the following:

If you are adding a new static multicast route, click the Add button.

Your settings are saved. The static multicast route is added.

If you are changing an existing static multicast route, click the Apply button.

Your settings are saved.

Main User Manual

451

Configure Multicast Routing

AV Line of Fully Managed Switches M4250 Series Main User Manual