NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 118)

6. Select the Admin mode Disable or Enable radio button to disable or enable the
UDP relay on the switch.
The default is Disable.
7. In the UDP Relay Global Configuration section, configure the following settings:
• Server Address: Enter the IPv4 address of the UDP relay server.
• UDP Port: Select one of the following types of UDP destination ports:
• Other: The UDP Port Other Value field becomes available so that you can
enter a custom UDP port number.
• dhcp: Relay DHCP (UDP port 67) packets.
• domain: Relay DNS (UDP port 53) packets.
• isakmp: Relay ISAKMP (UDP port 500) packets.
• mobile-ip: Relay Mobile IP (UDP port 434) packets
• nameserver: Relay IEN-116 Name Service (UDP port 42) packets
• netbios-dgm: Relay NetBIOS Datagram Server (UDP port 138) packets
• netbios-ns: Relay NetBIOS Name Server (UDP port 137) packets
• ntp: Relay network time protocol (UDP port 123) packets.
• pim-auto-rp: Relay PIM auto RP (UDP port 496) packets.
• rip: Relay Routing Image Protocol (RIP) (UDP port 520) packets
• tacacs: Relay TACACS (UDP port 49) packet
• tftp: Relay TFTP (UDP port 69) packets
• time: Relay time service (UDP port 37) packets
• UDP Port Other Value: If you select Other from the UDP Port menu, enter a
custom UDP port number in the range from 0 to 65535.
8. Click the Add button.
The UDP switch configuration is added.
The Hit Count field displays the number of UDP packets that are detected on the
UDP interface.
9. To save the settings to the running configuration, click the Save icon.
Main User Manual 118 Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual