Map dscp values to queues – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 458
9. To save the settings to the running configuration, click the Save icon.
Map DSCP values to queues
You can map an internal traffic class to a DSCP value.
To map DSCP values to queues:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select QoS > CoS > Advanced > IP DSCP to Queue Mapping.
The IP DSCP to Queue Mapping page displays.
The IP DSCP field displays an IP DSCP value from 0 to 63.
6. For each DSCP value, specify which internal traffic class to map the corresponding
IP DSCP value.
The queue number depends on specific hardware.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Configure the CoS interface settings for an interface
You can configure the trust mode for one or more interfaces and apply an interface
shaping rate to all interfaces or to a specific interface.
To configure CoS settings for an interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
Main User Manual
458
Configure Quality of Service
AV Line of Fully Managed Switches M4250 Series Main User Manual