NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 434)

The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > IPv6 Multicast > IPv6 PIM > Candidate RP Configuration.
The Candidate RP Configuration page displays.
6. From the Interface menu, select the interface.
7. In the Group Address field, specify the group IPv6 address that is transmitted in
candidate-RP-advertisements.
8. In the Prefix Length field, enter the group IPv6 prefix length that is transmitted in
candidate-RP-advertisements.
9. In the C-RP Advertisement Interval field, specify the period in seconds at which
candidate-RP-advertisements are sent as unicast traffic to the bootstrap router (BSR).
The range is from 1 to 16383 seconds.
10. Click the Add button.
Your settings are saved. The PIM candidate RP is added.
11. To save the settings to the running configuration, click the Save icon.
Delete an IPv6 PIM candidate rendezvous point
configuration
You can delete an IPv6 PIM candidate rendezvous point (RP) configuration that you no
longer need.
To delete an IPv6 PIM candidate RP configuration:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
Main User Manual 434 Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual