beautypg.com

NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 100

background image

4. Enter admin as the user name, enter your local device password, and click the Login

button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select System > Services > DHCP Server > DHCP Server Configuration.

The DHCP Server Configuration page displays.

6. Select the Admin Mode Disable or Enable radio button.

This setting specifies whether the DHCP service is enabled or disabled.

The default is Disable.

7. In the Ping Packet Count field, specify the number of packets a server sends to a

pool address to check for duplication as part of a ping operation.
The value can be 0 or from 2 to 10. Setting the value to 0 disables the function. The
default is 2.

8. Select the Conflict Logging Mode Disable or Enable radio button.

This setting specifies whether conflict logging on a DHCP server is enabled or
disabled. The default is Enable.

9. Select the BootP Automatic Mode Disable or Enable radio button.

This setting specifies whether BootP for dynamic pools is enabled or disabled. The
default value is Disable.

10. To exclude addresses, do the following:

a. In the IP Range From field, enter the lowest address in the range or a single

address to be excluded.

b. In the IP Range To field, to exclude a range, enter the highest address in the

range. To exclude a single address, enter the same IP address as specified in the
IP Range From field, or leave it as 0.0.0.0.

c. Click the Add button.

The addresses that must be excluded are added to the switch.

11. Click the Apply button.

Your settings are saved.

12. To save the settings to the running configuration, click the Save icon.

Main User Manual

100

Configure Switch System
Information

AV Line of Fully Managed Switches M4250 Series Main User Manual