NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 217)

Configure GARP settings for one or more interfaces You can configure
GARP settings for individual interfaces. These settings take effect only if GVRP mode,
GMRP mode, or both modes are enabled on the switch.
To configure GARP settings for one or more interfaces:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > VLAN > Advanced > GARP Port Configuration. The
The GARP Port Configuration page display.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
• 1: Only physical interfaces are displayed. This is the default setting.
• LAG: Only LAGs are displayed.
• All: Both physical interfaces and LAGs are displayed.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the GVRP Mode menu, select Enable or Disable to specify the GARP VLAN
registration protocol mode for the port.
If you select Disable, GVRP is not active and the join time, leave time, and leave all
time options are without any effect. The default is Disable.
9. From the GMRP Mode menu, select Enable or Disable to specify the GARP multicast
registration protocol mode for the port.
Main User Manual 217 Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual