Console port management access – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 542
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > Access > Telnet.
The Telnet page displays.
6. In the Outbound Telnet section, configure the following settings:
a. Next to Allow new telnet sessions, select the Disable or Enable radio button.
This selection specifies if the switch allows
new
outbound Telnet sessions. By
default, the Enable radio button is selected. If you disable this option, an
established session remains active until the session is ended.
b. In the Session Timeout (Minutes) field, specify the time in minutes after which
an inactive Telnet session is automatically ended.
The range is from 1 to 160 minutes. The default is 5 minutes.
c. In the Maximum Number of Sessions field, specify how many simultaneous
outbound Telnet sessions are allowed.
The maximum is 5, which is also the default.
7. Click the Apply button.
Your settings are saved.
The Current Number of Sessions field in the Outbound Telnet section displays the
number of current outbound Telnet sessions.
8. To save the settings to the running configuration, click the Save icon.
Console port management access
You can configure the settings for a serial port (console port) connection to the switch.
To configure the console port settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
Main User Manual
542
Manage Switch Security
AV Line of Fully Managed Switches M4250 Series Main User Manual