NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 216)

The following applies to GARP:
• Registration occurs only on interfaces that receive a GARP PDU with a declaration
or withdrawal.
• Deregistration occurs only if all GARP participants that are connected to the same
LAN segment as the interface withdraw the declaration.
Configure GARP switch settings You can globally enable GARP VLAN registration
protocol (GVRP) and GARP multicast registration protocol (GMRP) on the switch.
To configure GARP switch settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > VLAN > Advanced > GARP Switch Configuration.
The GARP Switch Configuration page displays.
6. Select the GVRP Mode Disable or Enable radio button to disable or enable GARP
VLAN registration protocol (GVRP) globally for the switch.
If GVRP is enabled, the switch can share VLAN IDs with devices in the network. the
The default is Disable.
7. Select the GMRP Mode Disable or Enable radio button to disable or enable GARP
multicast registration protocol (GMRP) globally for the switch.
If GVMP is enabled, the switch can share multicast information with devices in the
network. the The default is Disable.
8. Click the Apply button.
Your settings are saved.
It can take up to 10 seconds for GARP configuration changes to take effect.
9. To save the settings to the running configuration, click the Save icon.
Main User Manual 216 Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual