beautypg.com

Configure auto-voip protocol-based settings – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 219

background image

Configure Auto-VoIP protocol-based settings

To prioritize time-sensitive voice traffic over data traffic, protocol-based Auto-VoIP
determines if packets carry the following VoIP protocols:

Session Initiation Protocol (SIP)

• H.323

Signalling Connection Control Part (SCCP)

VoIP packets that come in on an interface on which Auto-VoIP is enabled are marked
with the specified CoS traffic class value.

To configure protocol-based settings for one or more interfaces:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Switching > Auto-VoIP > Protocol-based > Port Settings.

The Port Settings page displays.

6. In the Protocol Based Global Settings section, specify the following global settings:

a. From the Prioritization Type menu, select Traffic Class or Remark.

This specifies the type of prioritization.

b. From the Class Value menu, specify the CoS class value to be reassigned for

packets that the voice VLAN receives.
You can select a value in the range from 0 to 7.

Main User Manual

219

Configure Switching Information

AV Line of Fully Managed Switches M4250 Series Main User Manual