beautypg.com

Access default settings for the switch device ui, System features default settings – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 785

background image

Access default settings for the switch
device UI

The following table describes the default settings for access to the switch device UI.

(Nonconfigurable settings are not included in the table but might be included in the
data sheet, which you can download by visiting netgear.com/support/download/.)

Table 176. Default settings for access to the switch device UI

Default

Feature

169.254.100.100

IP address for management VLAN

192.168.0.239

Service port IP address

255.255.0.0

Subnet mask

0.0.0.0

Default gateway

1

Management VLAN ID

DHCP client enabled

Service port protocol

admin (read/write access)
No password (that is, the password is blank)
Upon first login, the admin user must specify a password.

Admin user

guest (read-only access)
No password (that is, the password is blank)
Upon first login, the guest user must specify a password.

Guest user

Eight characters

Minimum length for admin and guest passwords

Enabled

IPv6 management mode

Disabled

IPv6 address auto configuration

Disabled

DHCPv6

System features default settings

The following table describes the default settings for the system features that you can
configure.

(Nonconfigurable settings are not included in the table but might be included in the
data sheet, which you can download by visiting netgear.com/support/download/.)

Main User Manual

785

Software Default Settings and
Hardware Specifications

AV Line of Fully Managed Switches M4250 Series Main User Manual