beautypg.com

Configure dual image settings – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 753

background image

The System Information page displays.

5. Select Maintenance > Image Management > Copy.

The Copy page displays.

6. Select the Source Image Image1 or Image2 radio button to specify the image to

be copied.

7. Select the Destination Image Image1 or Image2 radio button to specify the

destination image.

8. Click the Apply button.

The image is copied.

9. To save the settings to the running configuration, click the Save icon.

Configure dual image settings

The Dual Image feature allows the switch to retain two images in permanent storage.
You can select which image must be loaded when the reboots, specify an image
description, or delete an image. This feature reduces switch down time when you are
upgrading or downgrading the software image.

Change the software image that loads when the switch starts or reboots

To change the image that loads during the boot process:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Maintenance > Image Management > Dual Image Configuration.

The Dual Image Configuration page displays.

6. Select the check box for the image that is

not

the active image (that is, the image for

which the Active Image fields shows False) but that you want the switch to run

after

it reboots.

Main User Manual

753

Maintenance and
Troubleshooting

AV Line of Fully Managed Switches M4250 Series Main User Manual