Port settings, Configure and display the port settings – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 294
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Address Table > Advanced > Static MAC Address.
The Static MAC Address page displays.
6. From the Interface menu, select the interface or LAG.
7. Select the check box for the MAC address.
8. Click the Delete button.
The static MAC address is removed from the MAC address table.
9. To save the settings to the running configuration, click the Save icon.
Port settings
For the physical ports and LAGs on the switch, you can configure and display the settings,
including the administrative mode of a port or LAG (by default, enabled) and speed
settings of a port (by default, automatically detected), add port descriptions, display
information about optional port transceivers that you might have installed, and configure
the port link flap settings.
Configure and display the port settings
You can configure and display the information for the physical port on the switch. Some
settings that apply to physical ports do not apply to LAGs.
Note: If you change, the autonegotiation, speed, or duplex mode for a physical port,
the switch might be inaccessible for a number of seconds while the new settings take
effect.
To configure and display the port settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
Main User Manual
294
Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual