Routing information protocol – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 383
Table 104. ARP Table Configuration
Description
Field
The total number of entries in the ARP table.
Total Entry Count
The highest value reached in the Total Entry Count field. This counter is
restarted when you change the size of the ARP table cache.
Peak Total Entries
The total number of active static entries in the ARP table.
Active Static Entries
The total number of configured static entries in the ARP table.
Configured Static Entries
The maximum number of static entries that can be defined.
Maximum Static Entries
Routing Information Protocol
Routing Information Protocol (RIP) is a protocol that switches and routers can use to
exchange network topology information. RIP is characterized as an interior gateway
protocol, and is typically used in small to medium-sized networks. A device that runs
RIP sends the contents of its routing table to each of its adjacent devices. When a route
is removed from the routing table, it is flagged as unusable by the other devices and,
after a certain period, removed from their routing.
Two versions of RIP exist:
•
RIPv1 (defined in RFC 1058):
-
Routes are specified by IP destination network and hop count.
-
The routing table is broadcast to all devices on the attached network.
RIPv2 (defined in RFC 1723):
-
The route specification also includes the subnet mask and gateway.
-
The routing table is sent to a multicast address, reducing network traffic.
-
Authentication is used for security.
You can configure an interface to do the following:
•
Receive packets in either or both formats.
•
Send packets formatted for RIPv1 or RIPv2, or send RIPv2 packets to the RIPv1
broadcast address.
•
Prevent any RIP packets from being received.
Main User Manual
383
Manage Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual