NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 685)

• If you select the Host radio button, enter a host source IPv6 address to match
the specified IPv6 address. If this field is left empty, it means any.
The source IPv6 address argument must be in the form documented in RFC 2373
where the address is specified in hexadecimal numbers using 16-bit values
between colons.
• Src L4: The options are available only if the selection from the Protocol Type
menu is TCP or UDP. Use the source L4 port option to specify relevant matching
conditions for L4 port numbers in the IPv6 ACL rule.
You can either enter the port number yourself or select one of the following
protocols from the menu:
• The source IP TCP port protocols are Domain, Echo, FTP, FTP data, www-http,
SMTP, Telnet, POP2, POP3, and BGP.
• The source IP UDP port protocols are Domain, Echo, SNMP, NTP, RIP, Time,
Who, and TFTP.
Each of these values translates into its equivalent port number, which is used as
both the start and end of the port range.
Select Other from the menu to enter a port number. If you select Other from the
menu but leave the field blank, it means any.
The only relevant matching condition for L4 port numbers is equal. This means
that an IPv6 ACL rule matches only if the Layer 4 source port number is equal to
the specified port number or port protocol.
• Dst: In the Dst field, enter a destination IPv6 address to be compared to a packet’s
destination IPv6 address as a match criterion for the selected IPv6 ACL rule:
• If you select the IPv6 Address radio button, enter an IPv6 address to apply
this criteria. If this field is left empty, it means any.
• If you select the Host radio button, enter a host source IPv6 address to match
the specified IPv6 address. If this field is left empty, it means any.
The source IPv6 address argument must be in the form documented in RFC 2373
where the address is specified in hexadecimal numbers using 16-bit values
between colons.
• Dst L4: The options are available only if the selection from the Protocol Type
menu is TCP or UDP. Use the destination L4 port option to specify relevant
matching conditions for L4 port numbers in the IPv6 ACL rule.
You can either enter the port number yourself or select one of the following
protocols from the menu:
• The destination IP TCP port protocols are Domain, Echo, FTP, FTP data,
www-http, SMTP, Telnet, POP2, POP3, and BGP.
• The destination IP UDP port protocols are Domain, Echo, SNMP, NTP, RIP,
Time, Who, and TFTP.
Main User Manual 685 Manage Switch Security
AV Line of Fully Managed Switches M4250 Series Main User Manual