Configure an igmp proxy interface – NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual
Page 407
Table 113. IGMP membership information (Continued)
Description
Field
The source IP addresses that are members of the multicast address.
Source Hosts
The expiration time that applies to each source IP address that is a member of
the multicast group. This is the period after which the source entry ages out.
Expiry Time
Configure an IGMP proxy interface
You can configure an IGMP proxy interface. The following requirements apply:
•
Routing, IGMP, and multicast must be globally enabled on the switch.
•
You must configure at least one routing interface.
•
The IGMP proxy interface cannot be the same interface as an IGMP routing interface.
To configure an IGMP proxy interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > IGMP > Proxy Interface Configuration.
The Proxy Interface Configuration page displays.
6. From the Interface menu, select the interface that must function as the IGMP proxy
interface.
7. From the Admin Mode menu, select Enable or Disable to enable or disable the
IGMP proxy capability on the interface.
The default is Disable.
Main User Manual
407
Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual