NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 193)

Reset the entire VLAN configuration to default setting You can reset all
VLAN configuration settings on the switch to factory default settings, with the exception
of the default VLAN (VLAN 1). The factory default values are as follows:
• All ports are assigned to the default VLAN of 1.
• All ports are configured with a PVID of 1.
• All ports are configured to an “Acceptable Frame Types value of Admit All Frames.”
• All ports are configured with ingress filtering disabled.
• All ports are configured to transmit only untagged frames.
• GVRP is disabled on all ports and all dynamic entries are cleared.
To reset the entire VLAN configuration to default settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > VLAN > Advanced > VLAN Configuration.
The VLAN Configuration page displays.
6. Select the Reset Configuration check box.
A confirmation windows displays.
WARNING: If you select this button and confirm your selection, all VLAN
configuration settings on the switch are reset to their factory default values.
7. Click the OK button.
All VLANs, except for the default VLAN, are deleted.
8. To save the settings to the running configuration, click the Save icon.
Change the internal VLAN allocation settings In most situations, you do not
need to change the internal VLAN allocation settings.
Main User Manual 193 Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual