beautypg.com

NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 336

background image

8. From the Keep Alive menu, select Enable to specify that loop protection must be

enabled on the port.
By default, loop protection is disabled for a port.

9. From the RX Action menu, select the action that the switch takes when a loop is

detected on the port:

• Log: Log the message when a loop is detected on the port.
• Disable: Disable the port when a loop is detected. This is the default setting.
• Both: Log and disable the port when a loop is detected.

10. Click the Apply button.

Your settings are saved.

11. To save the settings to the running configuration, click the Save icon.

12. To refresh the page, click the Refresh button.

The following table describes the nonconfigurable fields on the page.

Table 91. Loop protection interface configuration information

Description

Field

Indicates (Yes or No) whether a loop is detected on the interface.

Loop Detected

The number of packets that were received on the interface after the loop was

detected.

Loop Count

The time since the loop was detected.

Time Since Last Loop

The status of the interface (Enabled or Disabled).

Port Status

The reason that the interface was disabled. In addition to being disabled because

of loop protection, the interface can be disabled because of Unidirectional Link

Detection (UDLD), a broadcast storm, a unicast storm, and so on.

Errdisable Reason

The time that is left before the interface is reenabled through the autorecovery

process. The time is in the range from 30 to 604800 seconds.

Auto Recovery Time Left

(sec)

Main User Manual

336

Configure Switching Information

AV Line of Fully Managed Switches M4250 Series Main User Manual