beautypg.com

NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) User Manual

Page 358

background image

The range is from 4 to 1800. The default is 600.

19. From the Adv Management Config Flag menu, select Enable or Disable to enable

or disable the router advertisement “managed address configuration flag” for the
interface.
When enabled, end nodes use DHCPV6. When disabled, end nodes automatically
configure addresses. The default is Disable.

20. From the Adv Other Config Flag menu, select Enable or Disable to enable or

disable the router advertisement “other stateful configuration flag” for the interface.
The default is Disable.

21. From the Router Preference menu, select the router preference advertisements for

the interface.
You can select High, Medium, or Low. The default is Medium.

22. In the Adv Suppress Flag list, select Enable or Disable to enable or disable the

router advertisement suppression for the interface.
The default is Disable.

23. From the Destination Unreachables menu, select Enable or Disable to enable or

disable the transmission of ICMPv6 destination unreachables message on the
interface.
The default is Enable.

24. Click the Apply button.

Your settings are saved.

25. To save the settings to the running configuration, click the Save icon.

The following table describes the nonconfigurable fields on the page.

Table 98. IPv6 interface configuration information

Description

Field

The operational state of an interface. The default is Disable.

Operational Mode

Indicates if the link is up or down (Link Up or Link Down).

Link State

Configure prefix settings for an IPv6 routing interface

You can add or change one or more prefixes and associated settings for an IPv6 routing
interface.

Main User Manual

358

Manage Routing

AV Line of Fully Managed Switches M4250 Series Main User Manual