Altera Transceiver PHY IP Core User Manual
Page 682
Date
Document
Version
Changes Made
February 2013
1.9
• Reformatted.
• Removed QPI signals from Figure showing Arria V Native PHY
Common Interfaces. These signals are not available for Arria V
devices.
• Removed SDC constraints for 10G signals which are not
available for Arria V.
Arria V GZ Native PHY
February 2013
1.9
• Reformatted.
• Improved definition of
pll_powerdown
signal.
Cyclone V Native PHY
February 2013
1.9
• Reformatted.
• Removed information about PMA direct mode. PMA direct
mode is not supported for Cyclone V devices.
• Improved definition of
pll_powerdown
signal.
Transceiver Reconfiguration Controller
February 2013
1.9
• Reformatted.
• Expanded definition of mgmt_clk_clk to include constraints
when CvP is enabled and frequency range for Arria V GZ and
Cyclone V devices.
• Corrected address for channel 2 in register-based read examples.
Transceiver PHY Reset Controller
February 2013
1.9
• Reformatted.
• Improved definition of
pll_powerdown
and
rx_manual
signals.
Analog Parameters Set Using QSF Assignments
February 2013
1.9
• Reformatted.
• Added the following settings to the Arria V and Cyclone V
tables:
XCVR_RX_SD_ON, XCVR_RX_SD_OFF, XCVR_RX_SD_
THRESHOLD, CDR_BANDWIDTH_PRESET, XCVR_RX_COMMON_MODE_
VOLTAGE, XCVR_TX_COMMON_MODE_VOLTAGE, XCVR_TX_RX_DET_
ENABLE,
and
XCVR_RX_DET_MODE
.
Migrating from Stratix IV to Stratix V Devices
February 2013
1.9
• Reformatted.
Introduction
21-22
Revision History for Previous Releases of the Transceiver PHY IP Core
UG-01080
2015.01.19
Altera Corporation
Additional Information for the Transceiver PHY IP Core