Xcvr_tx_common_mode_voltage, Xcvr_tx_pre_emp_1st_post_tap – Altera Transceiver PHY IP Core User Manual
Page 626
The signal detect output is high when the receiver peak-to-peak differential voltage (diff p-p) > V
th
x 4.
For example, a setting of 6 translates to peak-to-peak differential voltage of 180mV (4*45mV). The V
diff p-
p
must be > 180mV to turn on the signal detect circuit.
Options
• 0-7
• 3
Assign To
Pin - RX serial data
XCVR_TX_COMMON_MODE_VOLTAGE
Pin Planner and Assignment Editor Name
Transmitter Common Mode Driver Voltage
Description
Transmitter common-mode driver voltage.
Note: Contact Altera for using this assignment.
Related Information
XCVR_TX_PRE_EMP_1ST_POST_TAP
Pin Planner and Assignment Editor Name
Transmitter Pre-emphasis First Post-Tap
Description
Specifies the first post-tap setting value.
Note: Legal values for this parameter vary with the data pattern and data rate. Refer to the Cyclone V
Device Datasheet for more information.
Options
0–31
Assign To
Pin - TX serial data
Related Information
19-32
XCVR_TX_COMMON_MODE_VOLTAGE
UG-01080
2015.01.19
Altera Corporation
Analog Parameters Set Using QSF Assignments