Altera Transceiver PHY IP Core - Manual (Page 509)

Name Direction Description
rx_clkslip[-1:0] Input
When you turn this signal on, the
deserializer performs a clock slip
operation to achieve word alignment.
The clock slip operation alternates
between skipping 1 serial bit and pausing
the serial clock for 2 cycles to achieve
word alignment. As a result, the period
of the parallel clock can be extended by 2
unit intervals (UI) during the clock slip
operation. This is an optional control
input signal.
Reconfig Interface Ports
reconfig_to_xcvr [(70-1):0] Input Reconfiguration signals from the
Transceiver Reconfiguration Controller.
grows linearly with the number of
reconfiguration interfaces.
reconfig_from_xcvr [(46-1):0] Output Reconfiguration signals to the
Transceiver Reconfiguration Controller.
grows linearly with the number of
reconfiguration interfaces.
tx_cal_busy[-1:0] Output When asserted, indicates that the initial
TX calibration is in progress. It is also
asserted if reconfiguration controller is
reset. It will not be asserted if you
manually re-trigger the calibration IP.
You must hold the channel in reset until
calibration completes.
rx_cal_busy[-1:0] Output When asserted, indicates that the initial
RX calibration is in progress. It is also
asserted if reconfiguration controller is
reset. It will not be asserted if you
manually re-trigger the calibration IP.
Table 15-17: Signal Definitions for tx_parallel_data with and without 8B/10B Encoding
The following table shows the signals within
tx_parallel_data
that correspond to data, control, and status
signals for a single 11-bit word.
TX Data Word Description
Signal Definitions with 8B/10B Enabled
tx_parallel_data[7:0]
TX data bus
tx_parallel_data[8]
TX data control character
tx_parallel_data[9]
Force disparity, validates disparity field.
15-26 Common Interface Ports
UG-01080
2015.01.19
Altera Corporation Cyclone V Transceiver Native PHY IP Core Overview
Send Feedback