Altera Transceiver PHY IP Core - Manual (Page 486)

Note: The Cyclone V Transceiver Native PHY provides presets for CPRI, GIGE, and the Low Latency
Standard PCS. The presets specify the parameters required to the protocol specified.
General Parameters
This section lists the parameters available on the General Options tab.
Table 15-2: General and Datapath Options
Name Range Description
Device speed grade fastest Specifies the speed grade.
Message level for rule violations
error
warning
Allows you to specify the message level, as
follows:
• error: Quartus II checker will not create an
instance with invalid parameters. You must
change incompatible parameter selections to
proceed.
• warning: Quartus II checker will allow
instance creation with invalid parameters, but
the instance will not compile successfully.
Datapath Options
Enable TX datapath On/Off When you turn this option On, the core includes
the TX datapath.
Enable RX datapath On/Off When you turn this option On, the core includes
the RX datapath.
Initial PCS datapath selection Standard The Cyclone V Native PHY only supports the
Standard datapath.
Number of data channels 1-36 Specifies the total number of data channels in
each direction.
UG-01080
2015.01.19
General Parameters 15-3
Cyclone V Transceiver Native PHY IP Core Overview Altera Corporation
Send Feedback