Altera Transceiver PHY IP Core - Manual (Page 414)

Performance and Resource Utilization for Arria V GZ Native PHY
Because the 10G PCS, Standard PCS, and PMA are implemented in hard logic, the Arria V GZ Native
PHY IP Core uses less than 1% of the available ALMs, memory, primary and secondary logic registers.
Parameter Presets
Presets allow you to specify a group of parameters to implement a particular protocol or application.
If you apply a preset, the parameters with specific required values are set for you. When applied, the preset
is in boldface and remains as such unless you change some of the preset parameters. Selecting a preset
does not prevent you from changing any parameter to meet the requirements of your design. The
following figure illustrates the Preset panel and form to create custom presets.
Figure 14-2: Preset Panel and Form To Create Custom Presets
Parameterizing the Arria V GZ Native PHY
This section provides a list of instructions on how to configure the Arria V GZ native PHY IP core.
Complete the following steps to configure the Arria V GZ Native PHY IP Core:
1. Under Tools > IP Catalog, select Arria V GZ as the device family.
2. Under Tools > IP Catalog > Interface Protocols > Transceiver PHY, select Arria V GZ Native PHY.
3. Use the tabs on the MegaWizard Plug-In Manager to select the options required for the protocol.
4. Click Finish.
UG-01080
2015.01.19
Performance and Resource Utilization for Arria V GZ Native PHY 14-3
Arria V GZ Transceiver Native PHY IP Core Altera Corporation
Send Feedback