Altera Transceiver PHY IP Core - Manual (Page 15)

Datapaths Stratix V Arria V Arria V GZ Cyclone V
Standard:
This datapath provides a
complete PCS and PMA for
the TX and RX channels. You
can customize the Standard
datapath by enabling or
disabling individual modules
and specifying data widths.
Yes Yes Yes Yes
10G:
This is a high performance
datapath. It provides a
complete PCS and PMA for
the TX and RX channels. You
can customize the 10G
datapath by enabling or
disabling individual modules
and specifying data widths.
Yes - Yes -
Related Information
• Analog Settings for Arria V Devices on page 19-2
• Analog Settings for Arria V GZ Devices on page 19-11
• Analog Settings for Cyclone V Devices on page 19-26
• Analog Settings for Stratix V Devices on page 19-34
Non-Protocol-Specific Transceiver PHYs
Non-protocol specific transceiver PHYs provide more flexible settings than the protocol-specific
transceiver PHYs. They include the Custom PHY, Low Latency PHY, and Deterministic Latency PHY IP
Cores.
These PHYs include an Avalon
® Memory-Mapped (Avalon-MM) interface to access control and status
registers and an Avalon Streaming (Avalon-ST) interface to connect to the MAC for data transfer.
Related Information
• Custom PHY IP Core on page 9-1
• Deterministic Latency PHY IP Core on page 11-1
• Low Latency PHY IP Core on page 10-1
Transceiver PHY Modules
The following sections provide a brief introduction to the modules included in the transceiver PHYs.
1-4 Non-Protocol-Specific Transceiver PHYs
UG-01080
2015.01.19
Altera Corporation Introduction to the Protocol-Specific and Native Transceiver PHYs
Send Feedback