Parameterizing the stratix v native phy, General parameters for stratix v native phy, Parameterizing the stratix v native phy -4 – Altera Transceiver PHY IP Core User Manual
Page 302: General parameters for stratix v native phy -4
Parameterizing the Stratix V Native PHY
This section provides a list of instructions on how to configure the Stratix V Native PHY IP core
Complete the following steps to configure the Stratix V Native PHY IP Core
1. Under Tools > IP Catalog, select Stratix V as the device family.
2. Under Tools > IP Catalog > Interface Protocols > Transceiver PHY, select Stratix V Native PHY.
3. Use the tabs on the MegaWizard Plug-In Manager to select the options required for the protocol.
4. Click Finish.
Generates your customized Stratix V Native PHY IP Core.
General Parameters for Stratix V Native PHY
This section describes the datapath parameters in the General Options tab for the Stratix V native PHY.
Table 12-2: General and Datapath Options
The following table lists the parameters available on the General Options tab. Note that you can enable the
Standard PCS, the 10G PCS, or both if you intend to reconfigure between the two available PCS datapaths.
Name
Range
Description
Device speed grade
fastest - 3_H3 Specifies the speed grade.
Message level for rule
violations
error
warning
When you select the error message level, the Quartus II
rules checker reports an error if you specify incompatible
parameters. If you select the warning message level, the
Quartus II rules checker reports a warning instead of an
error.
Datapath Options
Enable TX datapath
On/Off
When you turn this option On, the core includes the TX
datapath.
Enable RX datapath
On/Off
When you turn this option On, the core includes the RX
datapath.
Enable Standard PCS
On/Off
When you turn this option On, the core includes the
Standard PCS . You can enable both the Standard and 10G
PCS if you plan to dynamically reconfigure the Native
PHY.
Enable 10G PCS
On/Off
When you turn this option On, the core includes the 10G
PCS. You can enable both the Standard and 10G PCS if
you plan to dynamically reconfigure the Native PHY.
Initial PCS datapath
selection
Enable
Standard PCS
Enable 10G
PCS
Specifies the active datapath when you enable both the
Standard PCS and 10G PCS.
12-4
Parameterizing the Stratix V Native PHY
UG-01080
2015.01.19
Altera Corporation
Stratix V Transceiver Native PHY IP Core