Xaui phy general parameters, Xaui phy general parameters -4 – Altera Transceiver PHY IP Core User Manual
Page 144
a. General Parameters
b. Analog Parameters
c. Advanced Options Parameters
5. Click Finish to generate your customized XAUI PHY IP Core.
XAUI PHY General Parameters
This section describes the settings available on General Options tab.
Table 6-4: General Options
Name
Value
Description
Device family
Arria II GX
Arria V
Arria V GZ
Cyclone IV GX
Cyclone V
HardCopy IV
Stratix IV
Stratix V
The target device family.
Starting channel number
0-124
The physical starting channel number in the
Altera device for channel 0 of this XAUI PHY.
In Arria II GX, Cyclone IV GX, HardCopy IV,
and Stratix IV devices, this starting channel
number must be 0 or a multiple of 4.
In Arria V GZ and Stratix V devices, logical
lane 0 should be assigned to either physical
transceiver channel 1 or channel 4 of a
transceiver bank. However, if you have already
created a PCB with a different lane assignment
for logical lane 0, you can use the workaound
to remove this restric‐
tion.
Assignment of the starting channel number is
required for serial transceiver dynamic reconfi‐
guration. Check logical channel 0 restrictions
in Cyclone 5 and Arria 5.
6-4
XAUI PHY General Parameters
UG-01080
2015.01.19
Altera Corporation
XAUI PHY IP Core