Freescale Semiconductor MPC8260 - Manual (Page 98)

Overview
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
1-4 Freescale Semiconductor
– Transparent
– UART (low-speed operation)
— One serial peripheral interface identical to the MPC860 SPI
— One I
2
C controller (identical to the MPC860 I
2
C controller)
– Microwire compatible
– Multiple-master, single-master, and slave modes
— Up to eight TDM interfaces (four on the MPC8250 and the MPC8255)
– Supports two groups of four TDM channels for a total of eight TDMs (one group of four on
the MPC8250 and the MPC8255)
– 2,048 bytes of SI RAM
– Bit or byte resolution
– Independent transmit and receive routing, frame synchronization.
– Supports T1, CEPT, T1/E1, T3/E3, pulse code modulation highway, ISDN basic rate, ISDN
primary rate, Freescale interchip digital link (IDL), general circuit interface (GCI), and
user-defined TDM serial interfaces
— Eight transfer transmission convergence (TC) layers between the TDMs and FCC2 to support
inverse multiplexing for ATM capabilities (IMA) (MPC8264 and MPC8266 only)
— Eight independent baud rate generators and 20 input clock pins for supplying clocks to FCC,
SCC, and SMC serial channels
— Four independent 16-bit timers that can be interconnected as two 32-bit timers
• TC layer (MPC8264 and MPC8266 only)
— Each of the 8 TDM channels is routed in hardware to a TC layer block
– Protocol-specific overhead bits may be discarded or routed to other controllers by the SI
– Performing ATM TC layer functions (according to ITU-T I.432)
– Transmit (Tx) updates
– Cell HEC generation
– Payload scrambling using self synchronizing scrambler (programmable by the
user)
– Coset generation (programmable by the user)
– Cell rate by inserting idle/unassigned cells
– Receive (Rx) updates
– Cell delineation using bit by bit HEC checking and programmable ALPHA and
DELTA
parameters for the delineation state machine
– Payload descrambling using self synchronizing scrambler (programmable by the
user)
– Coset removing (programmable by the user)
– Filtering idle/unassigned cells (programmable by the user)