1 determining uead_offset (uead mode only), 2 vci filtering (vcif), Figure 30-22. vci filtering enable bits – Freescale Semiconductor MPC8260 User Manual
Page 959: Determining uead_offset (uead mode only) -39, Vci filtering (vcif) -39, Vci filtering enable bits -39, Vci filtering enable field descriptions -39, Section 30.10.1.2, “vci filtering, Vcif)
ATM Controller and AAL0, AAL1, and AAL5
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Freescale Semiconductor
30-39
30.10.1.1 Determining UEAD_OFFSET (UEAD Mode Only)
The UEAD_OFFSET value is based on the position of the user-defined extended address (UEAD) in the
UDC extra header.
shows how to determine UEAD_OFFSET: first determine the
halfword-aligned location of the UEAD, and then read the corresponding UEAD_OFFSET value.
30.10.1.2 VCI Filtering (VCIF)
VCI filtering enable bits are shown in
.
describes the operation of the VCI filtering enable bits.
0xB0
TCR
Hword (ABR only) Tag cell rate. The minimum cell rate allowed for all ABR
channels. An ABR channel whose ACR is less than TCR sends only
out-of-rate F-RM cells at TCR. Should be set to 10 cells/sec as defined in
the TM 4.0. Uses the ATMF TM 4.0 floating-point format. Note that the
APC minimum cell rate (MCR) should be at least TCR.
0xB2
ABR_RX_TCTE
Hword (ABR only) Points to total of 16 bytes reserved dual-port RAM area used
by the CP. Should be 16-byte aligned. User-defined offset from dual-port
RAM base.
—
Additional parameters
—
• For additional AAL1 CES parameters, refer to
• For additional AAL2 parameters, refer to
1
Offset from FCC base: 0x8400 (FCC1) and 0x8500 (FCC2); see
Section 14.5.2, “Parameter RAM
.”
Offset
0
15
16
31
0x0
UEAD_OFFSET = 0x2
UEAD_OFFSET = 0x0
0x4
UEAD_OFFSET = 0x6
UEAD_OFFSET = 0x4
0x8
UEAD_OFFSET = 0xA
UEAD_OFFSET = 0x8
Table 30-12. UEAD_OFFSETs for Extended Addresses in the UDC Extra Header
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Field
0
0
0
VC3
VC4
0
VC6 VC7 VC8 VC9 VC10 VC11 VC12 VC13 VC14 VC15
Figure 30-22. VCI Filtering Enable Bits
Table 30-13. VCI Filtering Enable Field Descriptions
Bits
Name
Description
0–2, 5
—
Clear these bits.
3, 4, 6,
7–15
VC
x
VCI filtering enable
0 Do not send cells with this VCI to the raw cell queue.
1 Send cells with this VCI to the raw cell queue.
Table 30-11. ATM Parameter RAM Map (continued)
Offset
1
Name
Width
Description