Figure 16-5. connection of the master address, Figure 16-6. connection of the slave address, Connection of the master address -9 – Freescale Semiconductor MPC8260 User Manual
Page 619: Connection of the slave address -9, Figure 16-5
CPM Multiplexing
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Freescale Semiconductor
16-9
Figure 16-5. Connection of the Master Address
•
For slave mode—The user has two groups of five address pins each. The user decides
which FCC uses each pin by programming CMXUAR[SADx]. Connect any UTOPIA pins
that are not connected to PowerQUICC II pins to GND. See
Figure 16-6. Connection of the Slave Address
FCC1
FCC2
M
S
M
S
M
S
M
S
5
5
5
5
5
5
5
5
8
5
8
5
0
1
2
3
4
4
3
2
1
0
These three bits always relate
These three bits always relate
to FCC2 master
Pins
to an FCC1 master.
These two address bits relate to the
master of FCC1 or FCC2 according
to the programming. Bit 4 is the msb.
FCC1
FCC2
M
S
M
S
M
S
M
S
5
5
5
5
5
5
5
5
8
5
8
5
0
1
2
3
4
4
3
2
1
0
Pins
These 5 address bits relate to the
slave of FCC1 or FCC2 according to
the programming. Bit 4 is the msb.
NOTE: To use FCC2 as shown, connect the FCC2 address bits reversed with
respect to the pinout address indexes. PHY address pins with no pin
connection should be connected to GND.