Freescale Semiconductor MPC8260 - Manual (Page 1144)

Inverse Multiplexing for ATM (IMA)
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
33-42 Freescale Semiconductor
33.4.5.1.1 IMA Link Transmit Control (ILTCNTL)
The fields of the ILTCNTL register are shown in Figure 33-21 .
Table 33-16 describes the ILTCNTL bit fields.
0x0C ITQFP Hword IMA link transmit queue fill pointer. This parameter forms bits 12-27 of
the pointer; bits 0-11 are from IMAEXTBASE, and bits 28-31 are zero.
Initialize this to the value of ITQSP. Refer to
Section 33.4.6.1, “Transmit
Queues.”
0x0E ITQXP Hword IMA link transmit queue extract pointer. This parameter forms bits
12-27 of the pointer; bits 0-11 are from IMAEXTBASE, and bits 28-31
are zero. Initialize this to the value of ITQSP. Refer to
Section 33.4.6.1,
“Transmit Queues “.
0x10 ITINTMSK Byte IMA transmit interrupt mask. Has the same format as the upper byte of
the IMA interrupt queue entry. Setting a bit enables the associated
interrupt; clearing a bit masks it.
For group-related events, only the mask register for the TRL is
referenced.
0x11 ITINTSTAT Byte IMA transmit interrupt status. Indicates the status of transmit interrupt
events.
0x12 LSHC Byte Stuff holdoff counter. Maintains the minimum five-frame spacing
between stuff events for non-TRL links. Must be initialized to zero. Set
to 4 by the microcode after a stuff event, and decrements after each
ICP cell is sent (saturating at zero). Signalling of ‘imminent stuff’ (and
subsequent stuff events) will not occur while this counter is non-zero.
1
Boldfaced entries indicate parameters that must be initialized by the user. All other parameters are
managed by the microcode and should be initialized to zero unless otherwise stated.
0 1 2 3 4 5 7
field TRL SES — TXSC IGNUM
Figure 33-21. IMA Link Transmit Control (ILTCNTL)
Table 33-16. ILTCNTL Field Descriptions
Bits Name Description
0 TRL Defines this link as the timing reference link (TRL) of the group.
0 This link is not the TRL.
1 This link is the TRL.
Note: One and only one link of the group must be programmed as the TRL. If zero or more than
one links are defined as TRL, erratic operation will occur.
1 SES Severely errored seconds. Set by software when a severely errored second indication is
detected. When set, causes the transmit stuff event counter to stop counting.
2 — Reserved, initialize to zero.
Table 33-15. IMA Link Transmit Table Entry (continued)
1
Offset Name Width Description