Freescale Semiconductor MPC8260 - Manual (Page 1239)

FCC HDLC Controller
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Freescale Semiconductor 36-15
Figure 36-8 shows interrupts that can be generated in the HDLC protocol.
Table 36-9. FCCE/FCCM Field Descriptions
Bits Name Description
0–7 — Reserved, should be cleared.
8 GRA Graceful stop complete. A graceful stop, which was initiated by the GRACEFUL STOP TRANSMIT
command, is now complete. GRA is set as soon as the transmitter finishes transmitting any frame
that is in progress when the command was issued. It is set immediately if no frame is in progress
when the command is issued.
9–10 — Reserved, should be cleared.
11 TXE Tx error. An error (CTS lost or underrun) occurs on the transmitter channel.
12 RXF Rx frame. A complete frame is received on the HDLC channel. This bit is set no sooner than two
clocks after receipt of the last bit of the closing flag.
13 BSY Busy condition. A frame is received and discarded due to a lack of buffers.
14 TXB Transmit buffer. Enabled by setting TxBD[I]. A buffer is sent on the HDLC channel. TXB is set no
sooner than when the last bit of the closing flag begins its transmission if the buffer is the last one
in the frame. Otherwise, TXB is set after the last byte of the buffer is written to the transmit FIFO
buffer.
15 RXB Receive buffer. When RXB = 1, a buffer for which the I bit is set in the corresponding BD was filled,
regardless if the end of a frame was completed in it.
16–21 — Reserved, should be cleared.
22 FLG Flag status changed. The HDLC controller stops or starts receiving HDLC flags. The real-time status
can be obtained in FCCS; see
Section 36.10, “FCC Status Register (FCCS) .”
23 IDL Idle sequence status changed. A change in the status of the serial line is detected on the HDLC line.
The real-time status can be read in FCCS; see
Section 36.10, “FCC Status Register (FCCS) .”
24–31 — Reserved, should be cleared.