4 internal receiver state (rstate)-hdlc mode, Figure 28-5. rx internal state (rstate) high byte, Internal receiver state (rstate)—hdlc mode -10 – Freescale Semiconductor MPC8260 User Manual
Page 858: Rx internal state (rstate) high byte -10, Rstate high-byte field descriptions -10, Section 28.3.1.4, “internal, Receiver state (rstate)—hdlc mode, 4 internal receiver state (rstate)—hdlc mode

Multi-Channel Controllers (MCCs)
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
28-10
Freescale Semiconductor
28.3.1.4
Internal Receiver State (RSTATE)—HDLC Mode
Internal receiver state (RSTATE) is a 4-byte register that provides transaction parameters associated with
SDMA channel accesses (like function code registers) and starts the receiver channel.
To start the channel the user must write 0xHH800000 to RSTATE, where HH is the RSTATE high byte
(see
). When the channel is active the CP changes the value of the 3 LSBs, hence these 3 bytes
must be masked if the user reads back the RSTATE.
RSTATE high-byte fields are described in
11–12
RQN
Receive queue number. Specifies the receive interrupt queue number.
00 Queue number 0.
01 Queue number 1.
10 Queue number 2.
11 Queue number 3.
13–15
NOF
Number of flags. NOF defines the minimum number of flags before frames:
000 At least 1 flag
001 At least 2 flags
....
111 At least 8 flags
0
1
2
3
4
5
6
7
Field
—
GBL
BO
TC2
DTB
BDB
Reset
—
R/W
R/W
Addr
0x20
Figure 28-5. Rx Internal State (RSTATE) High Byte
Table 28-5. RSTATE High-Byte Field Descriptions
Bits
Name
Description
0–1
—
Reserved, should be cleared.
2
GBL
Global. Setting GLB activates snooping (only the 60X bus can be snooped, this parameter is ignored
for local bus transactions).
3–4
BO
Byte ordering. Set BO to select the required byte ordering for the buffer. If BO is changed on-the-fly,
it takes effect at the beginning of the next frame or at the beginning of the next BD.
00 Reserved
01 Munged little-endian.
1x Big-endian
5
TC2
Transfer code. Contains the transfer code value of TC[2], used during this SDMA channel memory
access. TC[0–1] is driven with a 0b11 to identify this SDMA channel access as a DMA-type access.
Table 28-4. CHAMR Field Descriptions (continued)
Bits
Name Description