Freescale Semiconductor MPC8260 - Manual (Page 1137)

Inverse Multiplexing for ATM (IMA)
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Freescale Semiconductor 33-35
0x18 LINK 11 INFO Byte Status and control of link with LID = 11
0x19 LINK 10 INFO Byte Status and control of link with LID = 10
0x1A LINK 9 INFO Byte Status and control of link with LID = 9
0x1B LINK 8 INFO Byte Status and control of link with LID = 8
0x1C LINK 15 INFO Byte Status and control of link with LID = 15
0x1D LINK 14 INFO Byte Status and control of link with LID = 14
0x1E LINK 13 INFO Byte Status and control of link with LID = 13
0x1F LINK 12 INFO Byte Status and control of link with LID = 12
0x20 LINK 19 INFO Byte Status and control of link with LID = 19
0x21 LINK 18 INFO Byte Status and control of link with LID = 18
0x22 LINK 17 INFO Byte Status and control of link with LID = 17
0x23 LINK 16 INFO Byte Status and control of link with LID = 16
0x24 LINK 23 INFO Byte Status and control of link with LID = 23
0x25 LINK 22 INFO Byte Status and control of link with LID = 22
0x26 LINK 21 INFO Byte Status and control of link with LID = 21
0x27 LINK 20 INFO Byte Status and control of link with LID = 20
0x28 LINK 27 INFO Byte Status and control of link with LID = 27
0x29 LINK 26 INFO Byte Status and control of link with LID = 26
0x2A LINK 25 INFO Byte Status and control of link with LID = 25
0x2B LINK 24 INFO Byte Status and control of link with LID = 24
0x2C LINK 31 INFO Byte Program to 0x00.
0x2D LINK 30 INFO Byte Status and control of link with LID = 30
0x2E LINK 29 INFO Byte Status and control of link with LID = 29
0x2F LINK 28 INFO Byte Status and control of link with LID = 28
0x30 CRC10 Hword Microcode-managed area. Microcode will program this field
dynamically.
0x32 END-TO-END
CHANNEL Byte Program to any value desired for end-to-end
implementation-dependent signalling, or program to 0x00 if unused.
0x33 UNUSED Byte Program to 0x6A.
0x34 TAG Byte Internally-used tag value indicating that this is an ICP cell. Program to
0x80.
1
Boldfaced entries in the above table indicate parameters which must be initialized by the user. All other
parameters are managed by the microcode and should be initialized to zero unless otherwise stated.
Table 33-9. ICP Cell Template (continued)
1
Offset Name Width Description