M-AUDIO Pro Tools Recording Studio - Manual (Page 583)

Chapter 28: Beat Detective 565
Conforming Regions with Beat
Detective
(Audio Only)
After regions have been separated with Beat De-
tective, the regions can then be conformed us-
ing one of two modes:
Standard Conform Uses the session’s current
tempo map (Grid)
Groove Conform Uses groove templates.
Beat Detective will conform any selected region,
whether or not it was separated with Beat Detec-
tive. However, in order to successfully conform
regions with Beat Detective, the region start
points must correspond to the start of the mate-
rial that will align with the session’s bars and
beats. This should generally not be a problem if
the regions were separated with Beat Detective
(rather than manually separated or trimmed).
Standard Conform
This is similar to using the Region > Quantize to
Grid
command, but with one important differ-
ence: With a single operation, Beat Detective
can adjust the position of all regions, whether
they have a straight or swing feel.
To conform regions using Standard Conform:
1 In the Beat Detective window, select Region
Conform .
2 Make sure Standard is selected.
3 In the Edit window, if not already selected, se-
lect the separated regions you want to conform.
Make sure the selection’s start and end points
fall cleanly on the beat.
4 In the Beat Detective window, define or recap-
ture the selection as described in “Defining a
Beat Detective Selection” on page 552.
5 To affect how strongly the regions are con-
formed to the Grid (tempo map), select the
Strength
option and specify a percentage value
with either the slider or by typing in a value:
• Lower percentage values preserve the origi-
nal feel of the regions.
• Higher percentage values align the regions
more tightly to the tempo map, with 100%
aligning precisely to the tempo map.
6 To affect which regions are conformed, select
the Exclude Within option and specify a percent-
age value with the slider or by typing in a value:
• Lower percentage values ensure that re-
gions further away from the Grid are con-
formed, while those closer to the Grid are
not.
• Higher percentage values ensure that re-
gions closer to the Grid, as well as those fur-
ther away, are conformed.
Beat Detective, Standard Conform options
To “tighten up” the original feel while
retaining it, set the Strength option to
85–88%.
To “tighten up” the original feel while
retaining it, set the Exclude Within option
to 10–15%.