Apple Motion 4 - Manual (Page 994)

This filter causes rasterization in 3D groups.
Original image Black Hole applied
Parameters in the Inspector
Center: Sets the position of the center of the black hole.
Amount: Sets the amount of force pulling on your object. Values range from 0 (no gravity)
to 1000 (the entire object is pulled into the black hole).
Mix: Sets the amount of the original image to mix with the distorted image.
HUD Controls
The HUD contains the following control: Amount.
Bulge
This filter distorts an image as if pushed outward, as if something were “shoving” it from
behind.
This filter causes rasterization in 3D groups.
Original image Bulge applied
Parameters in the Inspector
Center: Sets the position of the center of the bulge.
Amount: Sets the amount of the bulge.
994 Chapter 16 Using Filters