Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 997)

Brocade Network Advisor SAN + IP User Manual 943
53-1002949-01
Creating a new encryption group
25
Configuring key vault settings for Thales e_Security keyAuthority (TEKA)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating a new encryption group”
on page 922.
Figure 375 shows the key vault selection dialog box for TEKA.
FIGURE 375 Select Key Vault dialog box for TEKA
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault’s public key certificate, or browse to
the desired location.
3. Enter the password you created for the Brocade group TEKA client.
4. If you are using a backup key vault, enter the IP address or host name, the name of the file
holding the backup key vault’s public key certificate in the fields provided, and the user name
and password for the backup key vault.
5. Click Next.
The Specify Master Key File Name dialog box displays. (Refer to Figure 376 .)