Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 2020)

1980 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP device properties
E
4. Click OK to close the dialog box.
Viewing VCS fabric properties
To view properties for a VCS fabric, complete the following steps.
1. Select Ethernet Fabrics from the view list on the Product List toolbar.
2. Right-click the VCS fabric in the Product List and select Properties.
The Fabric_Name Properties dialog box displays.
3. Review the device and port properties.
Serial Number The serial number of the AP.
Firmware version The firmware level of the AP.
Status IP address of the controller which manages the AP. Also displays the port
number if the AP is directly connected.
Controller \ Port IP address of the controller or switch connected to the AP. Also displays
the port number if the AP is directly connected.
Connected switch \ Port AP profile name.
Profile Name The RF domain name set for the AP.
RF Domain Name Location set for the AP.
Location Contact set for the AP.
Contact The time zone set for the AP.
Time Zone The country set for the AP.
Country The VLAN for control traffic set for the AP.
VLAN for Control Traffic The number of wireless clients or stations connected or associated to
the AP.
Client count The AP device MAC.
Field/Component Description
Properties tab Select to display information about the fabric.
Detailed Report button Click to launch the detailed cluster report.
Name The name of the fabric.
Alias The alias name. This is an editable field.
Host Name The host name. associated with the fabric.
System Name The name of the product.
IP Address The IP address (IPv4 or IPv6 format) of the product.
Product Type The fabric’s product type, which is a Layer 2 switch.
VCS Mode The VCS mode of the switch, which can be enabled or disabled.
VCS ID The VCS ID configured in the fabric.
Field/Component Description